If your deadlift stalls because your hands open before your back gives out, the fix depends on which grip strength is failing—and that determines which category of tool you buy. Grippers build crushing strength between fingers and palm, plate pinches and pinch blocks build the finger-and-thumb pinch, and thick-bar implements like Fat Gripz or axle bars build the support grip that holds a bar for long durations. This guide maps each major tool category to the grip type it trains, so you can pick based on your specific weakness rather than buying whatever gripper is trending.
Understanding the Three Pillars of Grip Strength
Grip strength is not one quality. The grip-focused retailer Gods of Grip breaks it into three distinct types, and the distinction matters because no single tool trains all three well. Crushing grip is the strength between your fingers and your palm—the squeeze you use to close your hand around something. Pinch grip is the strength between your fingers and thumb, which the same source notes is probably the least commonly used in everyday life, though it enables impressive grip feats. Support grip is the ability to hold onto an object for an extended duration.
That third category deserves special attention for lifters. Stronger by Science's evidence-based guide to grip training, written by Cameron Gill, describes support grip as the most common type of grip used in strength training, because nearly every barbell and dumbbell exercise asks your hands to simply hold on. Wikipedia's grip strength overview makes the same mapping from the training side: thick bar work on a two-inch or thicker bar—deadlifts, pull-ups, farmer's walks—trains the support grip, grippers train the crushing grip, and plate pinches train the pinch between fingers and thumbs only.
The practical takeaway: identify where your grip actually fails. If the bar slips out of a fully closed hand, support grip is the limiter. If you can't close your hand around the bar at all, crushing is. If only your thumb gives way on awkward objects, pinch is the gap.
Crushing Grip Tools: Squeeze for Power
Crushing grip is the most common type of grip strength, and coil-style hand grippers are its dedicated tool. For advanced lifters, the key consideration is resistance ceiling: most adjustable trainers top out well below what a strong lifter needs, according to RepReturn's comparison of grip trainers, which is why fixed high-resistance models like Captains of Crush remain a standard, and why the adjustable GD Iron Grip—rated roughly 55 to 198 pounds—stands out for bridging the two. BarBend's expert-tested guide, authored by Michael Shafer, points to threaded coil kits ranging from 100 to 300 pounds as another high-ceiling option.
Why does crushing strength matter for compound lifts? Gods of Grip notes that performing deadlifts and rows in the gym helps develop crush grip—and the relationship runs both ways, so dedicated crushing work can reciprocally reinforce your ability to keep a firm hold on those same lifts. RepReturn adds the broader context: a stronger grip carries over to nearly every pulling exercise—deadlifts, rows, pull-ups—where grip is often the limiting factor before the target muscle.
The trade-off is specificity. Grippers train the squeeze in isolation, which makes them efficient and portable, but they don't replicate holding a loaded bar for the duration of a heavy set. That hold is a support-grip demand.





